LOCK-N-STITCH, Inc.
1015 S. Soderquist Rd.
Turlock CA 95380
Tel: 800-736-8261 • Fax: 209-632-1740
Email: info@locknstitch.com • Website: www.locknstitch.com
Casting Repair Products > Full-Torque Products > Drilling & Tapping Alignment Fixture > Drilling and Tapping Alignment Fixtures and Parts > Order # FTDIP  


Order # FTDIP, Right Angle Drill Plate

Alignment fixture is mounted to a Cadillac Northstar block to make sure the holes are drilled and tapped perpendicular to the deck surface and centered to the original hole. Over the fender repairs are possible but when doing all 20 holes most people choose to pull the engine from the car.

Using these alignment fixtures will assure the inserts will be installed perpendicular to the surface when using hand held drills and taps.






Specifications

Shipping Weight
37.92 oz

Drill
Size 3 to 6

Tap
Size 3 to 6

Application
Used for drilling and tapping perpendicular to the surface. This fixture works with FT3 through FT6 drill and tap bushings.

Note
When ordering alignment tooling you will require a minimum of one bracket, one bushing, one alignment pin and one tap guide