|
|
|
|
Order # L60S-5, L60 Locks
|
|
|
|
|
|
The L60 lock is our largest lock. It is capable of creating an incredibly strong mechanical repair. The hole pattern for this lock can most easily be drilled with a magnetic base drill press. Install in castings up to seven inches thick by stacking one on top of another.
|
|
|
|
|
|
|
|
|
About Locks
|
|
Locks are used to add strength across a crack. Special drill jigs are used to create the precision pattern that locks are driven into.
All of our locks have a unique ability to pull the sides of the crack together. This is not done to close the crack but rather to prevent any spreading pressure from being applied to the repair site.
Our locks are punched or wire EDM cut from aircraft quality 4130 steel plate. The locks are intended to be stacked or laminated to a depth of 80% of the thickness of the material being repaired.
Use locks whenever the utmost strength is required. Always use the largest locks possible. Locks can not be bent around corners or curves. They must be installed flat. Use CASTMASTER® pins on curves and locks on flat surfaces. The use of locks and CASTMASTER® pins will produce the strongest repair possible.
Surface locks are available for installation on uneven surfaces. They range in thickness from 0.160" (L10 surface locks) to 1" thick (L60 surface locks.) Surface locks are intended to serve as a final "cap" on top of a stack of bottom locks in the drilled hole pattern. Bottom locks are thin (0.190") for stacking into the casting and creating a laminated effect.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
